Fancort Karry-Alls are adjustable racks that hold boards securely on two opposite sides for maximum protection during transport and storage, either horizontally or vertically.Three different models of Karry-Alls are featured, each with a different injection molded card guide to handle small, medium, large, very large and hard-to-hold boards. All the
card guides are molded in tough, reinforced conductive material that meets Mil Spec #B-81705-B for static discharge. The standard Karry-Alls can tolerate solvents and temperatures to 185°F. They are very easy to set up with rigid tubular aluminum extrusions and non-rotating nuts with large conductive plastic thumbscrews that lock into the extrusions.
Model 80 – For Medium to Large Boards
75 numbered slots measure .110” W x .155” D on a .210” pitch
- Easy board insertion with offset ribs
- Steel stiffeners and molded ribbing prevent flexing
- Standard card guides are 12.5” deep; optional 18” or 24”
guides for very large boards; P/N 80-18-1 - Optional carrying handle P/N KAH-2 as illustrated
Model 76 – For Small to Medium Boards
- 39 numbered slots measure .135” W x .135” D on a .260” pitch
- Easy board insertion with offset ribs
- Standard card guides are 4” deep; optional 8” deep guides
- Optional leg brackets for horizontal storage of 4” deep model only; P/N KAL-1;
- Optional carrying handle, P/N KAH-2
Model 79 – For Medium Boards and Boards with Hard to Hold Edges
- 18 unique double slots measure .125” W x .125” D inside a .600” W x .200” D slot for boards with components on the edge
- Standard card guides are 5.5” deep; optional 11” deep guides
- Model 79-20B-5 or 79-20B-11 fits standard 17” x 21” tote box
- Optional carrying handle, P/N KAH-2
- Optional leg brackets for horizontal storage of 5.5” deep models, P/N KAL-2
Magazine Racks for in-line automation with manual adjusting card guide
- Compatible with many assembly lines
- Rugged construction with steel reinforcing ribs and corner posts
- 50 slots* measure 3mm deep x 7mm high; first slot starts at 35mm from base
- Molded in rugged ABS with surface resistivity of 10 ohm/cm
- Tolerates temperatures to 60°C***. Optional models available. See below.
- Reversible models, NTC-092B, for top and bottom side assembly
- Load from either side with removable end stop
- Cut-out carrying handles in top panel; stackable
Magazine Racks for in-line automation with gear adjusting card guide
- Fast and simple gear adjusting card guide to maintain parallelism and ensure accurate setup
- Aluminum top and bottom
- Zero flexing of card guides with steel reinforcing supports and molded ribs
- Standard ABS model (N) tolerates 60ºC, plus optional models to 120ºC (M) and 200ºC (H)
- Surface resistivity of 10-4 to 10-6 ohm/cm
- Removable end stop
- Carrying handles on top and bottom
or by filling up the form below.
the contact information written below.